Motor stopper, men den elektriske bremsen reduserer ikke lenger bladets treghet

Lyden fra motor stopper når utløseren slippes, men bladet ruller gjentatte ganger mye lenger enn sagen tidligere gjorde før det stopper.

• Electric-brake control or motor feedback has failed
• Battery connection is intermittent during deceleration
• Blade, washer, or spindle condition is affecting coast behavior
• Expectation is based on an instant stop rather than a measurable change from normal operation

1. The product has an electric brake, but no owner procedure establishes an exact stop time. Always wait for a complete stop and guard closure regardless of brake behavior. Trigger release ends motor power and the repaired brake consistently shortens blade coast without noise, runout, or guard contact.

1. - Keep the shoe supported and hands on the handles until the blade stops completely and the lower guard closes - do not set the saw down during the coast.
2. Remove the battery and verify that the blade, clamp washer, screw, and lower guard are correctly assembled and free of visible damage or drag.
3. Fit a known-good fully charged compatible pack and make several clear no-load stop comparisons without contacting wood.
4. If the motor command ends but braking is consistently absent compared with the saw's established normal behavior, stop use and request authorized brake, mo

Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.

• FM-10: Fm Dcs578 10

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.