Kuttedybden vil ikke settes, låses, holdes eller nå sitt normale område

Skoen vil ikke gli til ønsket bladsynlighet, dybdespaken vil ikke klemme, dybden endres under kutting, eller maksimal dybde er tydelig utilgjengelig med et korrekt blad.

• Sawdust is packed at the depth guide, lever, or shoe slide
• Depth lever is loose, stripped, cracked, or incorrectly adjusted
• Shoe, depth guide, or guard is bent or obstructed

1. The depth moves freely, locks without slip, repeats the chosen exposure, and allows the specified normal range with the correct blade.

1. Remove the battery, loosen the depth lever, and clear exposed dry sawdust from the depth guide, lever, and shoe movement path.
2. Confirm the correct blade is centered and clamped, and inspect the shoe, guide, lever, and lower guard for bend, crack, interference, or missing hardware.
3. Move the shoe to expose about one-half tooth below the intended material and retighten the lever in the official direction before cutting.
4. - Check that the setting does not move by hand and that normal travel includes up to 2-9/16 inches at 90 degrees with the correct blade - if not, use authoriz

Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.

• FM-23: Fm Dcs578 23

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.