Bladet stanser, binder, klemmer eller sagen sparker tilbake i kuttet

Bladet er fysisk fanget eller saktes ned av kuttet, sagen løfter eller driver tilbake mot operatøren, eller en omstart forsøkes med tenner fastklemt i materialet.

• Workpiece is supported so the kerf closes and pinches the blade
• Blade is dull, dirty, bent, wrong, too deep, or twisted off the line
• Saw was started against the work or forced, turned, or backed in the cut
• Wet, knotty, treated, or unstable wood is loading the blade

1. The saw enters at full speed and completes a supported straight scrap cut without kerf closure, stall, twist, lift, or kickback.

1. Release the trigger immediately, hold the saw firmly until the blade stops and guard closes, then remove the battery before freeing the blade.
2. Support the work close to the cut so the cutoff cannot sag into the kerf, and remove nails, wire, unstable pieces, and binding forces.
3. - Inspect and replace a dull, dirty, bent, damaged, or wrong blade - set depth to about one-half tooth below the material and secure both adjustment levers.
4. Reposition the shoe flat and straight, bring the blade to full speed before contact, and feed at a rate that lets the blade cut without laboring or turning
5. - Make one supported scrap cut - if binding occurs with correct support, blade, depth, alignment, and feed, stop and route guard, shoe, spindle, and drive ali

Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.

• FM-18: Fm Dcs578 18

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.