Bladet klemmer, stanser eller sagen slår tilbake

Bladet klemmer, stanser i sporet, klatrer eller hopper, eller kan ikke starte trygt på nytt.

• Workpiece support lets the kerf close on the blade
• Blade is dull, damaged, dirty, or installed incorrectly
• Depth or bevel lever is loose or set incorrectly
• Saw is twisted, forced, or restarted in the kerf
• Fastener, knot, or offcut pinches the blade

1. The saw completes a supported cut without binding, stalling, or kickback.

1. Release the trigger and hold the saw still in the kerf.
2. Wait for a complete stop, remove the battery, then free and support the workpiece correctly.
3. Check blade condition, direction, depth, bevel locks, and the cut path for obstructions.
4. Restart only with the blade centered and teeth clear, then verify a controlled supported cut.

Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.

• FM-12: Fm Dcs575 12

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.