failure mode
FM-24: AUTOMATISK SPINDELLÅS HOLDER IKKE CHUCKEN
FM-24
Diagnostisk oversikt
FM-24
Sannsynlige rotårsaker
- Spindle has not reached the lock position
- Gear train is between teeth and needs slight hand rotation
- Spindle-lock or gearbox component is worn or broken
- Chuck body is loose on the spindle
Raske kontroller
- The spindle lock holds the empty chuck for normal hand tightening and loosening, or the lock fault is proven.
Reparasjonsforhåndsvisning
- Inspect for a loose chuck body, unusual free play, or grinding while keeping the tool unpowered.
- If the spindle never locks or the chuck body is loose, route the chuck, spindle lock, gearbox, or spindle to service.
- Remove the battery and test the spindle lock only with an empty chuck.
- Turn the chuck gently through a small angle, then retry the sleeve so the internal lock can engage.
Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.
Relaterte symptomer
Med battery fjernet og chucken tom, roterer hylsen spindelen og motor fritt i stedet for å gi nok lås til å stramme eller løsne chucken for hånd.
Med battery fjernet og kjeften tom, roterer 1. Fjern battery og test spindellåsen kun med en tom kjeft.
Inkludert i den fullstendige manualen
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.