FM-02: BATTERY VIL IKKE GLIDE FULLT INN I VERKTØYETS SKINNER

inspeksjon.

• Debris or a raised edge blocks a rail or contact channel
• Battery is misaligned or is not a compatible V20 interface
• Battery shell or tool rail support is swollen, cracked, or distorted
• Release latch or contact block is damaged and out of position

1. A compatible battery slides smoothly to the latched position, or the damaged insertion path remains out of service.

1. Dry-clean both rail paths and accessible contacts, then inspect the battery shell and tool foot for burrs, swelling, cracks, melting, or misalignment.
2. Approach the rails straight with a known-good compatible V20 battery and confirm whether it reaches the latch position smoothly.
3. If two sound packs bind at the same point, keep the tool unpowered and route the rail support, contact block, or housing damage to qualified service.
4. Stop pushing and withdraw the binding battery straight off the rails without twisting, striking, or levering it.

Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.

• En kompatibel V20 battery starter på verktøyets skinner men setter seg fast før den når normal innspent og låst posisjon.

  En kompatibel V20 battery starter på verktøyskinner, men setter seg fast 1. Stopp å skyve og trekk den fastklemte battery rett av skinnene uten

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.