FM-13: FM-13 LED DOES NOT LIGHT OR FLICKERS

The drive operates normally, but the integrated LED work light stays dark, flickers, or cuts in and out with trigger use.

• LED lens is covered by dust or residue
• Battery or tool contact is intermittent
• Trigger command is too slight to energize the light
• LED, wiring, or control circuit is damaged
• Housing impact has loosened the light assembly

1. LED lights steadily with trigger use and turns off after release.

1.

This is a preview of the troubleshooting guidance included in the full repair manual.

• The drive operates normally, but the work light stays dark, flickers, or cuts in and out with trigger use.

  The drive operates normally, but the work light stays 1. Remove battery and wipe the LED lens and openings dry.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.