0도 절단이 재료를 직각으로 통과하지 않습니다

베벨 포인터가 0으로 설정되고 슈가 평평해 보여도 완성된 절단이 작업 표면에 대해 일관되게 90도가 아닙니다.

• Zero-degree shoe calibration is out of adjustment
• Bevel lever is not fully locked or shoe moves during the cut
• Blade is bent, loose, or side-loaded
• Shoe is bent, dirty, or not resting flat on the work

1. An actual zero-bevel scrap cut measures square through the material and the locked setting repeats.

1. Release the trigger, wait for a full stop, remove the battery, set bevel to zero, and clean the shoe/blade reference surfaces.
2. Confirm a straight correctly clamped blade, a flat undamaged shoe, and a bevel lever that locks without movement.
3. Retract the lower guard with the battery removed, place the saw on its blade side, and compare the blade plate - not a tooth - to an accurate square agains
4. Adjust only the accessible 90-degree calibration screw by the official procedure, relock the bevel lever, and return the guard to normal operation.
5. - Make and square-check an actual supported scrap cut - if the setting will not calibrate or hold, stop and route the shoe, quadrant, pivot, and spindle align

이것은 전체 수리 매뉴얼에 포함된 문제 해결 안내의 미리보기입니다.

• FM-21: Fm Dcs578 21

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

공개 페이지에는 미리보기만 표시됩니다. 전체 수리 단계, 다이어그램 및 검증 절차를 다운로드하려면 전체 매뉴얼을 구매하세요.