作業灯は点灯するが、Motor とブレードが始動しない

トリガーを引くと作業灯が点灯し、制御電源があることを示すが、motor は無音でブレードは回転しません。

• Blade lock is stuck engaged or spindle is mechanically jammed
• Lower guard, blade, or clamp stack is contacting another part
• Trigger switch output, electronic module, motor, or internal wiring has failed
• Battery can power the light but cannot supply motor current

1. The worklight and motor respond together and the blade accelerates smoothly with the blade clear of material.

1. After seeing the light-only response, release the trigger, remove the battery, and wait until every moving part is fully still.
2. Check that the blade lock button returns, the blade is clamped correctly, the lower guard moves freely, and no debris or part is visibly jamming the blade
3. Install a known-good fully charged compatible pack and make one clear no-load start attempt without touching the blade lock.
4. If the light still responds but the motor remains silent, stop use and have the switch, module, motor, spindle, and internal wiring diagnosed by authorized

これは完全修理マニュアルに含まれているトラブルシューティングガイダンスのプレビューです。

• FM-08: Fm Dcs578 08

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公開ページはプレビューのみ表示されます。完全な修理手順、図解、確認手順をダウンロードするには完全版マニュアルを購入してください。