Sander berhenti dan mulai ulang dengan saklar tetap di I

Saat tanpa beban, sander mati dan menyala kembali meskipun saklar I/O tetap pada I.

• Battery latch is not holding the pack firmly
• Contacts are dusty, worn, or heat-damaged
• Battery protection is opening intermittently
• Switch or electronic control fault

1. The tool runs continuously for at least one minute at no load.

1. Set the switch to O, remove and reinstall the battery, then pull-check the latch.
2. - Periksa dan bersihkan kering rel dan kedua set kontak
3. Jalankan tanpa beban dengan paket yang diketahui baik dan jangan sentuh saklar dan dial.
4. Jika gerakan berhenti-mulai berulang dengan paket dingin yang kencang, lepaskan dan gunakan layanan resmi.

This is a preview of the troubleshooting guidance included in the full repair manual.

• FM-02: Fm Dcw210 02

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.