Pelindung Pisau Bawah Macet, Menutup Lambat, Kontak Dengan Pisau, Atau Tidak Menutup

Pelindung bawah yang diberi pegas tidak bergerak bebas melalui semua sudut/kedalaman, gagal menutup dengan cepat, menggosok pisau, atau membutuhkan bantuan manual saat pemotongan biasa.

• Sawdust, gum, or a small cutoff is obstructing the guard path
• Guard, retracting lever, pivot, or spring is bent, worn, damaged, or misassembled
• Blade or clamp stack is wrong and contacts the guard
• Guard was tied open, lubricated, or damaged by impact

1. With the battery removed, the lower guard moves freely without blade contact and snaps closed promptly at every tested depth and bevel position.

1. Remove the battery immediately and do not use the saw while the lower guard is missing, tied open, slow, damaged, or contacting the blade.
2. Use the retracting lever to move the guard through its full travel at several depth and bevel settings, checking for free motion and prompt spring closure.
3. - Clear dry sawdust, gum, and small offcuts externally - inspect the guard, lever, pivot, spring area, blade, and clamp stack for bend, rub, damage, or wrong
4. Confirm a correct centered blade and clean clamp area, and do not lubricate the guard/clamp region.
5. If the guard does not close freely and promptly at every setting, keep the battery out and have the complete guard system repaired by authorized service.

This is a preview of the troubleshooting guidance included in the full repair manual.

• FM-24: Fm Dcs578 24

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.