Kedalaman Potong Tidak Bisa Disetel, Dikunci, Ditahan, Atau Mencapai Rentang Normal

Alas tidak dapat digeser ke eksposur pisau yang diinginkan, tuas kedalaman tidak dapat mengunci, kedalaman berubah saat memotong, atau kedalaman maksimum jelas tidak tersedia dengan pisau yang benar.

• Sawdust is packed at the depth guide, lever, or shoe slide
• Depth lever is loose, stripped, cracked, or incorrectly adjusted
• Shoe, depth guide, or guard is bent or obstructed

1. The depth moves freely, locks without slip, repeats the chosen exposure, and allows the specified normal range with the correct blade.

1. Remove the battery, loosen the depth lever, and clear exposed dry sawdust from the depth guide, lever, and shoe movement path.
2. Confirm the correct blade is centered and clamped, and inspect the shoe, guide, lever, and lower guard for bend, crack, interference, or missing hardware.
3. Move the shoe to expose about one-half tooth below the intended material and retighten the lever in the official direction before cutting.
4. - Check that the setting does not move by hand and that normal travel includes up to 2-9/16 inches at 90 degrees with the correct blade - if not, use authoriz

This is a preview of the troubleshooting guidance included in the full repair manual.

• FM-23: Fm Dcs578 23

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.