Kunci Pisau Atau Perangkat Klem Tidak Membiarkan Pisau Dilepas Atau Diamankan

Kunci pisau tidak dapat mengunci atau melepaskan, screw penjepit tidak berputar dengan benar, atau screw dan ring luar tidak dapat mengamankan pisau saat pemasangan.

• Blade lock button is jammed, damaged, or being used incorrectly
• Clamping screw threads, wrench flats, spindle, or outer washer are damaged
• Sawdust or corrosion is packed in the clamp area

1. The blade lock engages only during hand rotation, the correct screw turns in the proper direction, the washer seats correctly, and the blade clamps firmly.

1. Remove the battery, set the saw on its side, and never press the blade lock while the saw is powered or use it as a brake.
2. - Hand-turn the spindle while pressing the blade lock until it engages - use the blade wrench and remember the right-hand screw loosens counterclockwise and t
3. - Remove only the clamping screw and outer washer, clean sawdust dry, and inspect the lock, screw, washer, spindle threads, and wrench flats for damage - do n
4. Reassemble with the large flat face of the outer washer against the blade and the beveled side out, then tighten the screw firmly by the official sequence.
5. If the lock will not engage/release or any clamp or spindle surface is stripped, cracked, rounded, or unable to hold torque, keep the battery out and use a

This is a preview of the troubleshooting guidance included in the full repair manual.

• FM-15: Fm Dcs578 15

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.