Port Debu Opsional Tidak Pas, Tetap Longgar, Tersumbat, Atau Ekstraksi Buruk

Port debu opsional dua bagian tidak dapat dipasang di atas pelindung atas, tidak akan tetap

• Back half tab is not in the casting notch or halves are misaligned
• Two mounting screws are loose, missing, wrong, or the port is cracked

1. The port seats firmly with its tab and two screws, leaves all guards/adjustments free, stays clear, and carries visible dust into a working extractor during a test cut.

1. Remove the battery, fully loosen the depth lever, and remove any hose before inspecting the port.
2. Clear chips dry and align the back half over the upper guard with its locating tab fully in the casting notch, then align the front half.
3. Install and secure the two correct mounting screws, restore the depth setting, and confirm the port does not obstruct the guard, shoe, or adjustments.
4. - Connect a clear compatible hose to a proven vacuum and make one controlled scrap cut - replace a cracked or nonfitting port, and use authorized service if t

This is a preview of the troubleshooting guidance included in the full repair manual.

• FM-28: Fm Dcs578 28

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.