FM-04: Kecepatan Bilah atau Gaya Potong Di Bawah Normal

Pisau berputar, tetapi kecepatan atau daya potong di bawah normal dalam potongan kayu yang didukung dengan benar.

• Battery charge or output is too low for the load
• Blade is dull, dirty, damaged, or unsuitable
• Blade rotation, size, arbor, or speed rating is incorrect
• Cut depth is excessive or feed pressure is too high
• Motor, bearing, or electronic drive fault

1. A clean supported test cut proceeds smoothly at normal blade speed.

1. Release the trigger, remove the battery, and inspect the installed blade.
2. Fit a clean sharp blade of the correct size, arbor, rotation, tooth count, and speed rating.
3. Set depth so about one-half tooth projects below the work and support the material near the cut.
4. - Test with a charged known-good pack and steady feed - if output stays low, seek service.

This is a preview of the troubleshooting guidance included in the full repair manual.

• Poros, kotak roda gigi, dan pisau
• Mata gergaji bundar
• Motor, gearcase, atau spindle

• Kecepatan Bilah atau Gaya Potong Di Bawah Normal

  Pisau berputar, tetapi kecepatan atau daya potong di bawah normal dalam potongan kayu yang didukung dengan benar.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.