FM-13: FM-13 WORKLIGHT IS DEAD, DIM, OR INTERMITTENT WHILE THE MOTOR RUNS

The motor runs normally but the LED worklight is dead, dim, or flickers intermittently during trigger use.

• Lens is dirty or obstructed
• Pack voltage or contact is marginal
• LED lead or lamp circuit is loose
• LED assembly has failed

1. The worklight turns on steadily whenever the trigger is depressed.

1.

This is a preview of the troubleshooting guidance included in the full repair manual.

• The motor runs normally, but the LED is dead, dim, or intermittent with trigger use.

  The motor runs normally, but the LED is dead, dim, or 1. Confirm the motor runs steadily, then remove the pack before inspecting the

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.