Symptoms
Browse documented symptoms and jump into matching repair guides from search results.
With no accessory load, the front drive makes abnormal metallic noise or feels rough.
0 related manual
Find guides →
The motor can be heard, but the front output remains still in both directions with the bit removed.
0 related manual
Find guides →
With the battery removed, the keyless chuck sleeve or jaws remain seized, or a clamped bit cannot be released by normal hand rotation.
0 related manual
Find guides →
Rotation and impact pulses are steady, but a normal fastener advances much more slowly than expected.
0 related manual
Find guides →
The bit rotates, but no impact pulses begin when a correct fastener provides normal resistance.
0 related manual
Find guides →
Battery or charger feels warm
0 related manual
Find guides →
Abnormal mechanical noise, strong vibration, or side play remains at no load.
0 related manual
Find guides →
The accessory slips from the fastener, damages it, breaks it, or drives it beyond the intended seat.
0 related manual
Find guides →
The chuck jaws open and close normally, but a straight compatible bit rotates or pulls out during moderate drilling or driving.
0 related manual
Find guides →
Unit shuts off abruptly
0 related manual
Find guides →
The tool or pack smokes, leaks, swells, smells burned, overheats severely, or exposes wiring.
0 related manual
Find guides →
The blade strokes steadily but cuts slowly, stalls easily, or needs excessive feed force.
0 related manual
Find guides →
360-डिग्री धूल पोर्ट जाम या ढीला है, या एक संगत नली/कपलर जुड़ा नहीं रहता।
0 related manual
Find guides →
The pack gets excessively hot, smells, discolors, or stops charging.
0 related manual
Find guides →
The chuck coasts much longer than normal after the trigger is released.
0 related manual
Find guides →
The drill runs steadily but drills slowly or cannot drive a normal fastener with correct setup.
0 related manual
Find guides →
A battery intended for the charger has physical damage, swelling, leakage, wetness, burned or melted terminals, or a deformed case. It may or may not still fit the charger.
0 related manual
Find guides →
A fully seated and retained pack powers the tool only in certain positions or interrupts when the tool or battery is moved, without a normal overload stop.
0 related manual
Find guides →
The direction lever will not reach forward, reverse, or center lock, or the selected position does not hold.
0 related manual
Find guides →
The tool starts and runs at no load, but stops abruptly on an ordinary fastener with no jam or twist.
0 related manual
Find guides →