symptom
A wet or damp pad is installed, but the robot produces no spray and leaves the floor dry.
A wet or damp pad is installed, but the robot produces no spray and STEPS
What this symptom means
A wet or damp pad is installed, but the robot produces no spray and STEPS
Related failure modes
Included in the full manual
- मूल कारण विश्लेषण
- आवश्यक उपकरण
- चरण-दर-चरण मरम्मत प्रक्रिया
- आरेख
- विस्फोट दृश्य
- मरम्मत के बाद जाँच
Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.
Related symptoms and error codes
Related models
Common symptoms
- Pressing CLEAN produces no light, tone, or movement.
- The charger light remains dark with the charger connected to a known live outlet.
- The charger indicates charging but does not reach solid green in the expected charging period.
- The robot runs normally but the charged battery lasts far less than a typical job.
- The robot powers down before the job is complete and gives no repeatable beep count.
- The pack will not click into the rear bay or springs loose during handling.
- The robot stops or will not proceed and reports one beep after the two-tone distress sound.
- The robot refuses to start and reports two beeps after the two-tone distress sound.
- The robot will not start, or stops after a pad falls off, and reports three beeps.