failure mode
FM-22: L'angle de biseau ne se règle pas, ne se verrouille pas, ne se maintient pas ou ne se lit pas correctement
La semelle ne s'incline pas dans la plage prévue, le levier de biseau ne serre pas, l'angle glisse pendant une coupe ou le pointeur/quadrant ne donne pas un angle répétable.
Aperçu diagnostique
La semelle ne s'incline pas dans la plage prévue, le levier de biseau ne serre pas, l'angle glisse pendant une coupe ou le pointeur/quadrant ne donne pas un angle répétable.
Causes probables
- Sawdust is packed at the pivot, quadrant, pointer, or lever
- Lever is loose, stripped, cracked, or incorrectly positioned
- Shoe, pivot, quadrant, or pointer is bent or worn
- Zero calibration or angle reading is being confused with a general locking failure
Vérifications rapides
- The shoe sets within its range, locks firmly without movement, and produces a repeatable verified bevel angle.
Aperçu de réparation
- Remove the battery and set the saw on a stable surface before touching the bevel lever or shoe.
- Clean the exposed pivot, quadrant, pointer, and lever dry, then inspect for cracks, bend, missing hardware, or a lever that cannot clamp.
- Loosen the lever counterclockwise, tilt the shoe to the desired marked angle within 0-57 degrees, and retighten the lever clockwise firmly.
- - Check for movement by hand and confirm the angle with a gauge or a controlled scrap cut - use FM-21 only for a zero-degree calibration error.
- If the shoe cannot move, lock, hold, or read repeatably, keep the saw out of service for authorized lever, pivot, quadrant, pointer, and shoe repair.
Ceci est un aperçu des conseils de dépannage inclus dans le manuel de réparation complet.
Réparations courantes
- Levier d'inclinaison, quadrant, pointeur et calibration zéro
- Semelle et pivots structurels
Symptômes associés
L'angle de biseau ne se règle pas, ne se verrouille pas, ne se maintient pas ou ne se lit pas correctement
La semelle ne s'incline pas dans la plage prévue, le levier de biseau ne serre pas, l'angle glisse pendant une coupe ou le pointeur/quadrant ne donne pas un angle répétable.
Inclus dans le manuel complet
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Les pages publiques n'affichent qu'un aperçu. Achetez le manuel complet pour télécharger les étapes de réparation, schémas et procédures de vérification complets.