failure mode
FM-34: FM-34 BLADE BINDS, STALLS, OR KICKS BACK IN THE CUT
FM-34 BLADE BINDS, STALLS, OR KICKS BACK IN THE CUT
Aperçu diagnostique
FM-34 BLADE BINDS, STALLS, OR KICKS BACK IN THE CUT
Causes probables
- Work is unsupported and the kerf closes
- Blade is dull, damaged, wrong, or set too deep
- Saw is twisted, fed backward, or side-loaded
- Hidden fastener, wet/warped stock, or loose adjustment changes the cut
Vérifications rapides
- The supported proof cut proceeds forward with the foot flat, open kerf, free guard, and no stall or reaction.
Aperçu de réparation
1.
Ceci est un aperçu des conseils de dépannage inclus dans le manuel de réparation complet.
Réparations courantes
- Cut quality fault
Symptômes associés
The blade pinches or stalls in the kerf, or the saw reacts backward during a cut.
The blade pinches or stalls in the kerf, or the saw reacts 1. Hold both handles, release the trigger, and never pull a spinning saw backward.
Inclus dans le manuel complet
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Les pages publiques n'affichent qu'un aperçu. Achetez le manuel complet pour télécharger les étapes de réparation, schémas et procédures de vérification complets.