failure mode
FM-29: FM-29 BEVEL SETTING SLIPS OR WILL NOT HOLD THE SELECTED ANGLE
The foot can be set to a bevel angle, but the angle slips or drifts during cutting due to locking or pivot issues.
Aperçu diagnostique
The foot can be set to a bevel angle, but the angle slips or drifts during cutting due to locking or pivot issues.
Causes probables
- Bevel lever is not fully locked
- Clamp/pivot surfaces are dirty
- Lever or clamp hardware is worn/damaged
- Foot or pivot is bent
Vérifications rapides
- The selected bevel remains fixed under hand pressure and through a controlled cut.
Aperçu de réparation
Steps to clean, reset, and lock the bevel angle securely.
Ceci est un aperçu des conseils de dépannage inclus dans le manuel de réparation complet.
Symptômes associés
The foot can be set to an angle, but moves after the bevel lever is locked or drifts during cutting.
The foot can be set to an angle, but moves after the bevel 1. Stop cutting, remove the battery, and mark the selected bevel position.
Inclus dans le manuel complet
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Les pages publiques n'affichent qu'un aperçu. Achetez le manuel complet pour télécharger les étapes de réparation, schémas et procédures de vérification complets.