Un corte a cero grados no es perpendicular al material

El puntero del bisel está ajustado a cero y la base parece plana, pero un corte completado no es consistentemente de 90 grados con la superficie de trabajo.

• Zero-degree shoe calibration is out of adjustment
• Bevel lever is not fully locked or shoe moves during the cut
• Blade is bent, loose, or side-loaded
• Shoe is bent, dirty, or not resting flat on the work

1. An actual zero-bevel scrap cut measures square through the material and the locked setting repeats.

1. Release the trigger, wait for a full stop, remove the battery, set bevel to zero, and clean the shoe/blade reference surfaces.
2. Confirm a straight correctly clamped blade, a flat undamaged shoe, and a bevel lever that locks without movement.
3. Retract the lower guard with the battery removed, place the saw on its blade side, and compare the blade plate - not a tooth - to an accurate square agains
4. Adjust only the accessible 90-degree calibration screw by the official procedure, relock the bevel lever, and return the guard to normal operation.
5. - Make and square-check an actual supported scrap cut - if the setting will not calibrate or hold, stop and route the shoe, quadrant, pivot, and spindle align

Esta es una vista previa de la guía de solución de problemas incluida en el manual de reparación completo.

• FM-21: Fm Dcs578 21

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Las páginas públicas muestran solo una vista previa. Compra el manual completo para descargar los pasos de reparación, diagramas y procedimientos de verificación completos.