La sierra corta lentamente, se siente débil, quema la madera o deja un corte áspero

La hoja alcanza una velocidad normal constante sin carga, pero el corte es inusualmente lento, requiere alimentación fuerte, quema la madera o produce astillado excesivo sin un paro completo.

• Blade is dull, dirty, wrong tooth count, installed backward, or unsuitable for the wood
• Depth is excessive or bevel/depth levers are not secured
• Feed is too fast, material is wet/dense, or the shoe is not flat
• Battery capacity is low or internal drive drag appears only under load

1. A sharp correct blade makes a controlled cut at normal feed with no burning, excessive splintering, laboring, or unusual battery heat.

1. Release the trigger, wait for a full stop, remove the battery, and inspect the cut rather than increasing force.
2. - Verify blade type, tooth condition, rotation direction, clean clamp stack, and secure mounting - replace a dull, dirty, damaged, or unsuitable blade.
3. Set depth to about one-half tooth below the material, lock depth and bevel, support the work, keep the shoe flat, and use an unforced feed rate.
4. - Compare one cut using a known-good fully charged compatible pack - if normal no-load speed remains but cutting stays weak with a correct sharp blade and set

Esta es una vista previa de la guía de solución de problemas incluida en el manual de reparación completo.

• FM-19: Fm Dcs578 19

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Las páginas públicas muestran solo una vista previa. Compra el manual completo para descargar los pasos de reparación, diagramas y procedimientos de verificación completos.