La Luz De Trabajo No Funciona Normalmente

La luz de trabajo está apagada o parpadea, o su retardo tras soltar el gatillo es anormal.

• Battery charge is too low for a valid test
• Trigger is not moving far enough to activate the light
• Lens area is blocked by dry debris
• LED or wiring is damaged
• Switch or electronic control fault

1. The worklight activates with the trigger and turns off after normal delay.

1. Remove the saw from the work and install a charged known-good battery.
2. Operate lock-off and trigger briefly while watching the light.
3. Brush only loose dry debris from the lens area and repeat the no-load timing check.
4. If the light stays dark, flickers, or times incorrectly, use qualified service.

Esta es una vista previa de la guía de solución de problemas incluida en el manual de reparación completo.

• FM-11: Fm Dcs575 11

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Las páginas públicas muestran solo una vista previa. Compra el manual completo para descargar los pasos de reparación, diagramas y procedimientos de verificación completos.