La Sierra O El Battery Se Sobrecalientan O El Apagado Por Calor Se Repite

La sierra o el paquete se calientan anormalmente, pierden potencia o se detienen durante un corte soportado.

• Vents are blocked by sawdust or the saw is covered
• Blade is dull or the feed load is excessive
• Battery is hot, cold, low, damaged, or unsuitable
• Cut depth, support, or material is overloading the saw
• Motor, bearing, controller, or battery fault

1. A light supported cut completes without abnormal heat or shutdown.

1. Release trigger, remove pack, and place both on a clear surface.
2. Let saw and pack cool naturally, then brush the vents and inspect for damage or odor.
3. - Fit sharp blade and good pack - correct depth and support - test lightly.
4. If abnormal heat or shutdown returns, stop use and seek qualified service.

Esta es una vista previa de la guía de solución de problemas incluida en el manual de reparación completo.

• FM-14: Fm Dcs575 14

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Las páginas públicas muestran solo una vista previa. Compra el manual completo para descargar los pasos de reparación, diagramas y procedimientos de verificación completos.