failure mode
FM-10: El Ajuste De Profundidad No Se Fija, Bloquea Ni Mantiene
La zapata no se ajusta ni sujeta a la profundidad, o la profundidad de corte cambia durante el uso.
Resumen de diagnóstico
La zapata no se ajusta ni sujeta a la profundidad, o la profundidad de corte cambia durante el uso.
Causas probables
- Depth lever is not fully loosened or tightened
- Sawdust is packed in the shoe slide or pivot
- Depth scale, lever, pivot, or shoe is bent or damaged
- Fastener or clamping surface is worn or loose
- Internal or structural adjustment repair is required
Comprobaciones rápidas
- The selected depth stays fixed through a supported test cut.
Vista previa de reparación
- Remove the battery, place the saw on a stable surface, and loosen the depth lever.
- Brush the slide dry and move the shoe through its full range.
- Set depth so about one-half tooth projects below the workpiece, then tighten the lever firmly.
- - Push-test and make a scrap cut - if depth moves or the lever will not lock, seek service.
Esta es una vista previa de la guía de solución de problemas incluida en el manual de reparación completo.
Soluciones habituales
- Palanca de profundidad y zapata
- Ensamblaje de profundidad, bisel o zapata
Síntomas relacionados
El Ajuste De Profundidad No Se Fija, Bloquea Ni Mantiene
La zapata no se ajusta ni sujeta a la profundidad, o la profundidad de corte cambia durante el uso.
Incluido en el manual completo
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Las páginas públicas muestran solo una vista previa. Compra el manual completo para descargar los pasos de reparación, diagramas y procedimientos de verificación completos.