FM-22: Skråningsvinklen vil ikke indstilles, låses, holdes eller aflæses korrekt

Skoen vil ikke vippe gennem det tilsigtede område, skråningshåndtaget vil ikke klemme, vinklen glider under et snit, eller indikatoren/kvadranten giver ikke en gentagelig vinkel.

• Sawdust is packed at the pivot, quadrant, pointer, or lever
• Lever is loose, stripped, cracked, or incorrectly positioned
• Shoe, pivot, quadrant, or pointer is bent or worn
• Zero calibration or angle reading is being confused with a general locking failure

1. The shoe sets within its range, locks firmly without movement, and produces a repeatable verified bevel angle.

1. Remove the battery and set the saw on a stable surface before touching the bevel lever or shoe.
2. Clean the exposed pivot, quadrant, pointer, and lever dry, then inspect for cracks, bend, missing hardware, or a lever that cannot clamp.
3. Loosen the lever counterclockwise, tilt the shoe to the desired marked angle within 0-57 degrees, and retighten the lever clockwise firmly.
4. - Check for movement by hand and confirm the angle with a gauge or a controlled scrap cut - use FM-21 only for a zero-degree calibration error.
5. If the shoe cannot move, lock, hold, or read repeatably, keep the saw out of service for authorized lever, pivot, quadrant, pointer, and shoe repair.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• Vinkelhåndtag, kvartskive, peger og nulkalibrering
• Sko og strukturelle drejepunkter

• Skråningsvinklen vil ikke indstilles, låses, holdes eller aflæses korrekt

  Skoen vil ikke vippe gennem det tilsigtede område, skråningshåndtaget vil ikke klemme, vinklen glider under et snit, eller indikatoren/kvadranten giver ikke en gentagelig vinkel.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.