FM-10: SNITTET ER IKKE VINKELRET ELLER SKRÅNINGSVINKEL ER UNØJAGTIG

FM-10 SNITTET ER IKKE VINKELRET ELLER SKRÅNINGSVINKEL ER UNØJAGTIG

• Blade is loose, warped, or not seated
• Shoe is not square to the blade at zero
• Bevel scale or 90-degree alignment needs calibration
• Shoe is bent or work support is uneven
• Guide technique or blade choice causes wandering

1. A measured scrap cut matches the selected 0-degree or bevel setting and the shoe remains locked.

1. Set the desired bevel from the scale, tighten the bevel knob, set and lock depth, and use a marked line, fence, or straightedge on supported work.
2. Make and measure a scrap cut; if calibration cannot be achieved or the blade wanders with sound setup, service the shoe, spindle, or bearing.
3. Remove the battery, set the bevel to zero, and place a square between the shoe and blade body while avoiding the carbide teeth.
4. Confirm the blade, washer, and bolt are seated and secure, and inspect the shoe for bending; use the manual 90-degree alignment procedure only when needed.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• Saven fuldfører snittet, men et 0-graders snit er ikke vinkelret, skråningen stemmer ikke overens med skalaen, eller snittet vandrer fra den tilsigtede vinkel.

  Saven fuldfører snittet, men et 0-graders snit er ikke vinkelret, 1. Fjern battery, indstil hældningen til nul, og placer en vinkel mellem skoen og

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.