FM-05: SAVEN SLUKKER ELLER SKÆRER AFBRUDT UNDER BELASTNING

FM-05 SAVEN SLUKKER ELLER SKÆRER AFBRUDT UNDER BELASTNING

• Electronic protection stopped overload, heat, or deep discharge
• Battery latch or contacts are intermittent
• Battery is weak or not fully charged
• Blade is dull, pinched, or set too deep
• Switch, motor, wiring, or gear train is failing

1. The saw maintains steady power through a supported test cut without contact movement, overload shutdown, or intermittent stopping.

1. Inspect for a sharp correct blade, one-tooth depth, tight depth and bevel locks, and work support that keeps the kerf from closing on the blade.
2. Test a known-good battery on supported scrap with gentle feed; if cutouts repeat after load and fit are corrected, stop and service the switch, motor, wiring, or gear train.
3. Release the trigger, hold the saw still until the blade stops, remove the battery, and let both tool and pack cool before inspection.
4. Check the battery latch and contacts, clear the cooling vents dry, and fully charge the battery; use FM-15 for a pack that moves or will not latch.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• Saven slukker under belastning

  Saven slukker under belastning Elektronisk beskyttelse, svag pakke, intermittent kontakt, overbelastning eller intern fejl; brug FM-05.

• Saven starter normalt men stopper, pulserer eller mister strøm under et snit, især når den presses eller når battery flyttes.

  Saven starter normalt, men stopper, pulserer eller mister strøm under et snit, især

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.