FM-06: STRØMAFBRYDELSE NÅR VÆRKTØJ ELLER BATTERY BEVÆGES

bevægelsesafhængig strømafbrydelse.

• Dry contamination, wear, or damage at the battery contacts
• Battery shell or latches allow electrical movement despite physical retention
• Tool contact block or internal wiring is loose
• Trigger, direction switch, brush, or motor connection is intermittent

1. Ordinary handling no longer interrupts power, or the internal intermittent path is conclusively routed to service.

1. Repeat with a known-good compatible battery to separate a pack-side intermittent condition from the tool-side path.
2. With the chuck empty, make one brief no-load test while changing only normal hand orientation; do not flex, strike, shim, or hold the pack in place.
3. If a proven battery still causes cutout with ordinary movement, remove it and route the contact block, wiring, switch, brush, or motor path to service.
4. Release the trigger and remove the battery before inspecting the contacts, latches, stem, and tool rail path for heat, burning, looseness, or impact damage.
5. Dry-clean the accessible contacts and latch surfaces, then install the original pack until the release latch pass an unpowered pull test.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• battery forbliver fysisk låst, men motor, LED eller begge slukker og tænder, når værktøjet eller battery bevæges gennem almindelig arbejdsorientering.

  battery forbliver fysisk låst, men motor, LED'en eller 1. Slip aftrækkeren og fjern battery før inspektion af kontakterne,

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.